Blade mCP X V2 RTF Bedienerhandbuch PDF herunterladen (Seite 11)

11

EN

Troubleshooting Guide

Problem Possible Cause Solution

Helicopter will not

initialize

Throttle at high position

Resetcontrolswiththrottlestickand

throttle trim at center or lowest setting

Switchesnotinnormalposition

SetflightmodetoOFF/0andexitthrottle

hold.

Pitch or throttle servo reversing im-

properly conﬁgured

Reset servo reversing

Refer to “Programming your Transmitter”

Helicopter will not

spool up

Throttle hold on

Turn off HOLD with throttle low and trim

centered or low.

Refer to “Throttle Hold”

Low battery voltage Completely recharge ﬂight battery

Motor power decreases

during flight

Receiver uses default soft Low

VoltageCutoff(LVC)

Recharge flight battery or replace battery

that is no longer performing

Cannot turn off

throttle hold

StuntModeswitchstillon

SetflightmodetoOFF/0andexitthrottle

hold.

Throttle not at low position

Resetcontrolswiththrottlestickand

throttle trim at center or lowest setting

Powers off when flying

upsidedown(inverted)

StuntModeoff

When flying, switch stunt mode to ON/1

before flying inverted.

Will not bind properly to

non-computer radio

Helicopter binds differently to

non-computer radios

Release bind button/ switch after

applying left rudder. Do not hold the bind

button/ switch after applying left rudder.

Poor tail authority

Tailboomiscracked Replace tail boom

The tail rotor blade is warped

or bent.

Twistrotorbladebackintoposition

or replace.

Climb out rate is greatly

reduced

Main gear has slipped on the main

shaft.

Pushmaingearbackintoposition.

LED on receiver ﬂashes

rapidly and aircraft will

notlinktotransmitter

Less than a 5-second wait after

powering transmitter and before

connecting ﬂight battery to aircraft

Disconnect then reconnect ﬂight

battery to aircraft

Transmitter too near aircraft

during binding process

Move powered transmitter a few

feet from aircraft, disconnect and

reconnect ﬂight battery to aircraft

Aircraft not bound to transmitter Bind transmitter to aircraft receiver

Aircraft bound to different model

memory(ModelMatch™radiosonly)

Selectcorrectmodelmemoryon

transmitter

Low charge in transmitter

batteries

Replace or charge transmitter

batteries

Helicopter vibrates or

shakesinight

Damaged rotor blades, spindle or

blade grips

Checkmainrotorbladesandbladegrips

forcracksorchips.Replacedamaged

parts. Replace bent spindle.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17 18

Kommentare zu diesen Handbüchern

Keine Kommentare