Blade mCP X V2 RTF Bedienerhandbuch PDF herunterladen (Seite 7)

Transmitter and Receiver Binding

If you purchased an RTF model, the transmitter is bound to the model at the factory.

To bind or re-bind your mCP X to your chosen transmitter, please follow the directions below:

BindingistheprocessofprogrammingthereceiverofthecontrolunittorecognizetheGUID(GloballyUnique

Identier)codeofasinglespecictransmitter.Youneedto‘bind’yourchosenSpektrum

™

or JR

DSM

technology equipped aircraft transmitter to the receiver for proper operation.

NOTICE:UsetheNon-ComputerRadiobindinginstructionsifyouareusingaDX4eorDX5etransmitter

with the mCP X BNF.



Binding Procedure for Non-Computer Radio (DX4e, DX5e)

1. Disconnect the ﬂight battery from the helicopter.

2.Poweroffthetransmitterandmoveallswitchestothe0position.

3.Connecttheightbatterytothehelicopter.The3-in-1ControlunitLEDashesafter5seconds.

4.Pushinonthetrainerswitchorbuttonwhilepoweringonthetransmitter.

5.MovetheruddercontrolsticktofullleftafterthetransmitterLEDlightsashtwice.

6.Releasethetrainerswitch/button.Continuetoholdtheruddercontrolsticktofullleftuntiltheblue

LEDonthe3-in-1controlunitissolid.

7.Releasetheruddercontrolstick.

8.Pushinonthetrainerswitch/button.TheblueLEDonthe3-in-1controlunitashestoconrmthe

helicopter is in non-computer mode.

9. Disconnect the ﬂight battery and power the transmitter off.



Binding Procedure for Computer Radios:

1. Disconnect the ﬂight battery from the helicopter.

2.Poweroffthetransmitterandmoveallswitchestothe0position.

3.Connecttheightbatterytothehelicopter.The3-in-1ControlunitLEDashesafter5seconds.

4.Pushinonthebindswitch/buttonwhilepoweringonthetransmitter.

5.After2–3seconds,releasethebindswitch/button.

6.Movetheruddercontrolsticktofullright.Continuetoholdtheruddercontrolsticktofullrightuntil

theblueLEDonthe3-in-1controlunitissolid.

7.Releasetheruddercontrolstick.

8.Disconnecttheightbatteryandpowerthetransmitteroff.

The throttle will not arm if the transmitter’s throttle control is not put at the lowest position and the stunt mode

switch is not in the 0 position.

If you encounter problems, obey binding instructions and refer to the troubleshooting guide for other

instructions.Ifneeded,contacttheappropriateHorizonProductSupportofce.

ForalistofcompatibleDSMtransmitters,pleasevisitwww.bindny.com.

If the swashplate moves up and down when the trainer switch is moved, the helicopter is in computer

transmitter mode; repeat binding procedure.

1 2 3 4 5 6 7 8 9 10 11 12 ... 17 18

Keine Kommentare

Blade mCP X V2 RTF Bedienerhandbuch Seite 7