Blade mSR RTF Bedienerhandbuch PDF herunterladen (Seite 6)

H AB CDEFG H

Mode 1 Power

LED

Aileron (Left/Right)

Throttle (Up/Down)

Throttle

Trim

Aileron

Trim

ON/OFF

Switch

Rudder

Trim

Elevator

Trim

Rudder (Left/Right)

Elevator (Up/Down)

Mode 2 Power

LED

Aileron (Left/Right)

Elevator (Up/Down)

Elevator

Trim

Aileron

Trim

ON/OFF

Switch

Rudder

Trim

Throttle

Trim

Rudder (Left/Right)

Throttle (Up/Down)

Transmitter Control

Installing the Flight Battery

When pressed down, trim buttons make a sound that

increases or decreases in pitch at each pressing. The

middle or neutral trim position is heard as a middle

tone in the pitch range of the sounds. The end of the

control range is sounded by a series of beeps.

1. Lower the throttle to the lowest setting.

2. Power on the transmitter.

3. Install the battery in the helicopter by sliding it into

the battery mounting supports/slots just below the

main gears. Slide the battery into the slots with the

label facing downward and the connector oriented

toward the back of the helicopter.

4. Connect the battery cable to the

5-in-1 control unit.

NOTICE: Do not allow the helicopter to move until the

blue LED on the 5-in-1 control unit turns solid.

CAUTION: Always disconnect the Li-Po battery

from the aircraft ESC when not ﬂ ying to avoid

over-discharging the battery. Batteries discharged to

a voltage lower than the lowest approved voltage may

become damaged, resulting in loss of performance and

potential ﬁ re when batteries are charged.

1 2 3 4 5 6 7 8 9 10 11 ... 55 56

Kommentare zu diesen Handbüchern

Keine Kommentare

Blade mSR RTF Bedienerhandbuch Seite 6

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Ferngesteuertes Spielzeug Blade mSR RTF