Blade 200 SR X RTF Bedienerhandbuch PDF herunterladen (Seite 10)

Elevator

Elevator down

Elevator up

Left Side View Left Side View

Aileron

Motor

Aileron left

Aileron right

Rear ViewRear View

Control Tests

Test the controls prior to the ﬁ rst ﬂ ight to ensure the servos, linkages and parts operate correctly. Ensure the throttle is in

the low position when doing the control tests.

Place the helicopter outdoors on a clean, ﬂ at and level surface (concrete or asphalt) free of obstructions. Always stay clear

of moving rotor blades.

CAUTION: Keep pets and other animals away from the helicopter. Animals may injure themselves if they

attack or run toward the helicopter.

1. The motor beeps twice when the helicopter’s ESC arms properly. Before you continue, conﬁ rm that throttle is at full

low position.

WARNING: Stay at least 30 feet (10 meters) away from the helicopter when the motor is running.

Do not attempt to ﬂ y the helicopter at this time.

2. Ensure the throttle is lowered completely. Ensure the transmitter is still setup as described in the Transmitter Setup

Table. Slowly increase the throttle until the blades begin to spin. The main blades spin clockwise when viewing the

helicopter from the top. The tail rotor blades spin counterclockwise when viewing the helicopter from the right-hand

side.

NOTICE: If the main rotor blades are spinning counterclockwise, reduce the throttle to low immediately. Disconnect the

battery from the helicopter and reverse any two motor wire connections to the ESC and repeat the motor control test.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16 17 18

Keine Kommentare

Blade 200 SR X RTF Bedienerhandbuch Seite 10