Blade 200 SR X RTF Bedienerhandbuch PDF herunterladen (Seite 5)

NOTICE: Charge only batteries that are cool to the touch and

are not damaged. Look at the battery to make sure it is not

damaged e.g., swollen, bent, broken or punctured.

1. Connect the AC to DC adapter to an AC outlet.

2. Connect the AC to DC adapter to the charger.

3. Connect the battery balance lead to the charger.

The connector is keyed to prevent reverse

polarity connection.

4. Always disconnect the ﬂ ight battery from the charger

immediately upon completion of charging.

LED Indicators

Red Flashing LED: Input power with no battery connected

R ed and Green Solid LEDs: Battery connected and

charging

Red Solid LED: Charge complete

Red and Green Flashing LEDs: Charge error

Charging a fully discharged (not over-discharged) 800mAh battery takes approximately 1–1.5 hours.

The charger can also be powered through the DC alligator clips. Connect them to a 11.5–15V DC power source, noting

proper polarity.

CAUTION: Do not connect to AC and DC power sources at the same time. Doing so may cause a short circuit,

resulting in damage to the product, personal injury or property damage.

NOTICE: Always connect cable polarities correctly. Consult the battery instructions, safety sheet or product support before

using a 12V battery with sources other than a standard AC wall outlet.

Installing the Transmitter Batteries (RTF)

Replace the transmitter batteries

when the transmitter beeps.

Battery Charging

1 2 3 4 5 6 7 8 9 10 ... 17 18

Keine Kommentare

Blade 200 SR X RTF Bedienerhandbuch Seite 5